What Would Cause My Mazda RX7 To Produce High HC & CO?

The feed back test will utilize a 5-gas analyzer (the smog machine can be used for this test) and propane. The smog technician will introduce propane to the intake system and ensure the oxygen sensor is sensing the propane as an increase in CO (carbon monoxide), and ordering the emissions computer to decrease fuel delivery the instant propane is added to air intake stream. This test should be done after the engine has sufficiently warmed up and while it is running at idle. If no change in fuel delivery is seen there is feedback problem. The diagnose then should turn to which part of the feedback system is not working right.

Using a multimeter voltmeter the smog repair mechanic should observe the voltage output of the oxygen sensor as propane is added. The voltage coming from the oxygen sensor should increase. If no voltage increase is seen the O2 sensor is not working. The sensor should be replaced and the test started over. If voltage increase is noticed the smog technician needs to ensure voltage increase is also present at the computer input terminal. If voltage is present at the terminal as well next the technician must ensure the emissions computer output to the fuel injectors are lowering "injector pulse rates". At the end of the fuel system feedback test it will be know whether the high emissions your vehicle is producing is an electronic or mechanical fault. The technician can then further diagnose the failure.

The additional sensors which should be inspected for proper operation (and which also play a significant role in determining air/fuel ratio) are the Engine Coolant Temperature (ECT) sensor and the Manifold Absolute Pressure (MAP) sensor. If the coolant temperature sensor is not operating properly (not sending the correct voltage signal to the Engine Control Module) the ECM will not be able to properly calculate how much fuel to deliver to the combustion chambers. When the engine is cold the ECM is programmed to deliver a richer fuel mixture (more fuel). As the engine warms up, the ECM will lean out the mixture. Ensuring the ECT is sending the correct voltage to the ECM is important for correct air/fuel ratio (optimum is 14:7). The MAP sensor measures the amount of intake manifold vacuum/pressure. This sensor must send accurate information to the ECM as well, in order for the ECM to calculate exactly how much fuel to add to the air entering the combustion chambers.

Please read more about smog check failure here.