Smogtips
CHOOSE YOUR CITY OR ZIPCODE:
Within:
SELECT SMOG CHECK TYPE:  

Join the community and post your question. Use our Ask-A-Tech for free now! ASE experts standing by.

Forum > Failed Smog Test > Question

Changed the Car Battery and Failed Smog Check

I changed the car battery. It failed the smog check because there is no data; the tech said no monitors. I drove it 250 miles and it failed the smog check again. I drove my car for another 110 miles and took it to Honda dealer to check the monitors. They said it will cost me $320.00. How can I reset the car monitor? Is there any place to check the car monitor and reset it at cheaper cost?


Answer:

You will need to drive your Honda for at least 200-300 miles through various driving conditions in order to complete the required Emission Monitors. Sometimes simply driving an extend length of time does not necessary mean the emission monitors will run. Your Honda’s emission monitors are internal self-tests which the Engine Control Unit performs to ensure your is not polluting and is running efficiently. The entire process of self-testing various emission control systems is called a Drive Cycle. Follow the emission drive cycle trace below. Obey all traffic laws while performing drive cycles. Perform at your own risk.

HOW TO PERFORM A HONDA DRIVE CYCLE

The following is a Honda OBDII Drive Cycle Pattern.

COLD START: Begin from Cold Start, and ignition in OFF position for at least 1 hour. ensure your Honda’s fuel tank is between 1/4 and 3/4 full and engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature. Do not leave the key on prior to the cold start or the heated oxygen sensor diagnostic may not run.

IDLE TIME: Run your Honda’s engine (do not drive) for 2 1/2 minutes with the air conditioner on and rear defroster on. During this period the ECU will be running the Oxygen Sensor Heater self-test, Air Injection System Passive Air test, EVAP Purge "No Flow" test, Misfire Detection.

ACCELERATE: Turn off the air conditioner and rear defroster and begin driving. As soon as possible apply half throttle until 55mph is reached. The ECU will now run self-tests on the Misfire Detection, Fuel Trim, and EVAP Purge Flow.

HOLD STEADY: Now hold your vehicle speed steady at 55mph for three minutes. During this time the Oxygen Sensor O2 response, Air Intrusive (AIS System), EGR Flow, Purge Valve, Misfire Detection, and Fuel Trim diagnostics will be performed.

DECELERATE: During this step you want to slowly let off the accelerator pedal. Do not brake or shift your Honda in order to slow down. It is important to let the vehicle coast along gradually slowing down to 20 mph. The ECU will once again self-test the EGR System, EVAP Purge System and Long Term Fuel Trims.

ACCELERATE: Go ahead and accelerate again at 3/4 throttle until 55-60mph is reached. This will perform the same self tests as during the first acceleration step.

HOLD STEADY: Hold steady speed once again. This time at 55mph for five minutes. During this time, in addition to running the self-tests as during the first HOLD STEADY step, the ECU will perform the catalyst monitor diagnostics. If the catalyst (Catalytic Converter) is marginal or the battery has been disconnected, it may take 5 complete driving cycles to determine the state of the catalyst,or in order to Complete the CAT Monitor.

DECELERATE: This will perform the same diagnostics as in the first Deceleration. Remember not to press your Honda’s brake or shift gears during deceleration.

This should complete the drive cycle on your Honda. To ensure all monitors are complete use a scan tool to view the monitors. You may want to complete the drive cycle 2-3 times.


posted by SmogTips Support

 

View SmogTips.com in: Desktop / Mobile