Smogtips
CHOOSE YOUR CITY OR ZIPCODE:
Within:
SELECT SMOG CHECK TYPE:  

Join the community and post your question. Use our Ask-A-Tech for free now! ASE experts standing by.

Forum > Smog Check Repair > Question

How to Complete Nissan Xterra Drive Cycle

We have a 2003 Nissan Xterra which failed the smog check. No trouble codes and no engine problems. The only thing is that the EGR monitor is not ready. I driven a lot of miles already but it will not complete. I don't know if I need a drive cycle for a Nissan Xterra, or if just driving it more will do the trick. Do you have any suggestions? How can I get the emission monitors ready for the smog check?


Answer:

Typically driving for a few hundred miles over the course of a week, in both highway and city conditions, is enough to get the emission monitors to run. Usually the required drive cycle parameters are met over the course of 200-300 miles. However, due to different driving habits, the criteria required to run a monitor may not always be met; and a Nissan Xterra drive cycle must be performed.

Take extra caution while performing drive cycles on public roadways. If you think you will be unable to follow the Nissan Xterra Drive Cycle below safely, seek the assistance of a smog check repair station or Nissan dealership.

How to Complete a Nissan Xterra Drive Cycle

Pre-Conditioning Requirements:

Ensure the MIL (malfunction indicator lamp) is not on.

Gas tank fuel level must be between 15% and 85% at all times.

Drive cycle must start while engine is cold. Best performed in the morning, after being parked overnight. The actual requirement is that the engine be between 68 and 86 degrees F prior to the start of the drive cycle.

Drive Trace:

A. Start your vehicle and idle engine until coolant temperature reaches 160F (until normal operating temperature is reached). Usually 20 minutes at idle will accomplish this.

B. Using a timer, idle the engine for an additional 1 1/2 minutes.

C. Begin driving. Accelerate smoothly to 56 mph with the transmission in (D) and overdrive ON, then release gas pedal and coast for 10 seconds.

D. Accelerate to 56 mph and maintain speed for at least 10 minutes. Use smooth and quick acceleration and maintain speed as constant as possible.

E. Stop and idle your Nissan Xterra for 10 seconds.

F. Accelerate to 25 mph in 10 seconds and hold gas pedal steady for 20 seconds. Use smooth and quick acceleration and maintain speed as constant as possible.

G. Repeat steps E and F eight (8) times. Decelerate (coast down) to 15 mph and then drive for 13 minutes at speeds between 15mph and 35mph.

H. Accelerate to 53-56 mph and maintain speed for at least 6 minutes. In this step it is more important to maintain accelerator pedal position than speed. Therefore you are allowed 3 mph fluctuation in speed, but must try and keep the gas pedal steady.

- End of Drive Cycle -

If all emissions systems are functioning properly, completing the drive cycle above will set the emission monitors (also known as readiness flags) required to pass the smog check. We recommend performing the drive cycle at least twice before visiting a smog check station. Explain to the smog technician that you've been attempting to complete a drive cycle prior to arriving at their shop.


posted by SmogTips Support

 

View SmogTips.com in: Desktop / Mobile