Smogtips
CHOOSE YOUR CITY OR ZIPCODE:
Within:
SELECT SMOG CHECK TYPE:  

Join the community and post your question. Use our Ask-A-Tech for free now! ASE experts standing by.

Forum > Failed Smog Test > Question

Nissan Pathfinder Replaced Battery Failed Smog Test

Hello, I replaced the battery in my '12 Nissan Pathfinder and now I can't pass my smog check. I was told to do a drive cycle by the tech but I can't find how or what I need to do to complete this. If you could help or point me in the right direction that would be great. Thank you.
Answer:

Replacing the battery erased your Nissan Pathfinder's emission monitors. Driving your Pathfinder through a drive cycle will allow it to complete (make ready) the emission monitors (also known as Readiness Flags) needed to pass the smog check.

Typically driving for a few hundred miles over the course of a week, in both highway and city conditions, is enough to get the emission monitors to run. Usually the required drive cycle parameters are met over the course of 200-300 miles. However, due to different driving habits, the criteria required to run a monitor may not always be met; and a Nissan Pathfinder drive cycle must be performed.

Take extra caution while performing drive cycles on public roadways. If you think you will be unable to follow the Nissan Pathfinder Drive Cycle below safely, seek the assistance of a smog check repair station or Nissan dealership.

How to Complete a Nissan Pathfinder Drive Cycle

Pre-Conditioning Requirements:

Ensure the MIL (malfunction indicator lamp) is not on.

Gas tank fuel level must be between 15% and 85% at all times.

Drive cycle must start while engine is cold. Best performed in the morning, after being parked overnight. The actual requirement is that the engine be between 68 and 86 degrees F prior to the start of the drive cycle.

Drive Trace:

A. Start your vehicle and idle engine until coolant temperature reaches 160F (until normal operating temperature is reached). Usually 20 minutes at idle will accomplish this.

B. Using a timer, idle the engine for an additional 1 1/2 minutes.

C. Begin driving. Accelerate smoothly to 56 mph with the transmission in (D) and overdrive ON, then release gas pedal and coast for 10 seconds.

D. Accelerate to 56 mph and maintain speed for at least 10 minutes. Use smooth and quick acceleration and maintain speed as constant as possible.

E. Stop and idle your Nissan Xterra for 10 seconds.

F. Accelerate to 25 mph in 10 seconds and hold gas pedal steady for 20 seconds. Use smooth and quick acceleration and maintain speed as constant as possible.

G. Repeat steps E and F eight (8) times. Decelerate (coast down) to 15 mph and then drive for 13 minutes at speeds between 15mph and 35mph.

H. Accelerate to 53-56 mph and maintain speed for at least 6 minutes. In this step it is more important to maintain accelerator pedal position than speed. Therefore you are allowed 3 mph fluctuation in speed, but must try and keep the gas pedal steady.

- End of Drive Cycle -

If all emissions systems are functioning properly, completing the drive cycle above will set the emission monitors (also known as readiness flags) required to pass the smog check. We recommend performing the drive cycle at least twice before visiting a smog check station. Explain to the smog technician that you've been attempting to complete a drive cycle prior to arriving at their shop, and allow them to check the monitors before performing the actual smog inspection.


posted by SmogTips Support

 

View SmogTips.com in: Desktop / Mobile