Smogtips
CHOOSE YOUR CITY OR ZIPCODE:
Within:
SELECT SMOG CHECK TYPE:  

Join the community and post your question. Use our Ask-A-Tech for free now! ASE experts standing by.

Forum > Failed Smog Test > Question

What is the Drive Cycle for a BMW M6?

Hello. I need the drive cycle for a 2006 BMW M6. My emission monitors are not ready and the car won't pass the smog check. Any advise? I've already driven it like 400 miles... still nothing.


Answer:

Your BMW M6 will need to have all the emission monitors "ready" or "complete" before it can pass the smog test. 2001 & newer BMW M6's must have all the monitors ready, except the EVAP. The EVAP monitor is the only one that is allowed to remain incomplete and your vehicle still pass the smog test. NOTE: You'll notice below, the secondary AIR monitor runs when the engine is cold, and best when the BMW has been sitting overnight. We recommend ensuring the monitor's parameters (requirement for engine to be cold) are being met. If the AIR injection pump is not running in the mornings when the engine is first started and the weather is cold, the AIR monitor will not complete.

You will need to perform a drive cycle on your BMW M6 if you have replaced the battery, disconnected the battery, or cleared the codes after a repair. The driving cycle performs a diagnostic test on all the emission systems and enures your vehicle is not polluting.

How to Perform a BMW M6 Drive Cycle

Begin by: (Make sure you have between 1/4 and 3/4 fuel in the gas tank. The EVAP test will not run while your BMW has a full tank of gas or the gas tank is near empty. Ensure there are no pending or active trouble codes and that the check engine light is not on. Start the drive cycle from a cold start; preferably on a cold morning.

A. Start engine and idle for approximately 2 minutes and 10 seconds. This tests the Secondary Air Injection, O2 Heater, EVAP/Purge No Flow, and Misfire systems. If your BMW achieves closed loop, the fuel trim will also be tested as well.

B. Begin driving. Accelerate to 55 MPH and maintain steady speed for 3 minutes and 15 seconds. During this drive segment the ECU is checking closed-loop operation and oxygen sensor response time.

C Release the accelerator pedal and coast down to 20 MPH without shifting or touching the brake or clutch (if equipped). Continue to STEP D once your vehicle speed reaches 20 MPH.

D. Accelerate to 40-60 MPH and maintain steady speed for 15 minutes. The catalyst monitor is being run now.

E. Decelerate to a complete stop and idle while the transmission is in PARK or neutral for 5 minutes. The ECU is testing the system for EVAP leaks.

F. End of Drive Cycle

If readiness status of all monitors do not switch to “ready,” ensure preconditions are met, and complete a new drive cycle after the engine has cooled overnight. The BMW M-Series drive cycle (drive trace) requires driving both highway and city speeds. If you feel you might be unable to complete the drive cycle safely, please seek assistance from a BMW repair center or smog check repair station. Conduct this drive cycle at your own risk.


posted by SmogTips Support

Related BMW M6 Drive Cycle questions and answers you might find useful:
 

View SmogTips.com in: Desktop / Mobile