Getting your Hyundia Accent to set its Emission Monitors can be tricky. We usually recommend driving a vehicle which has incomplete at least 200-300 miles; and over the course of a week. Below however we've outlined a generic OBDII drive cycle which well followed correctly should complete your car's monitors.
Begin by: (Make sure you have between 1/4 and 3/4 fuel in the gas tank. The EVAP test will not run while your Hyundai Accent has a full tank of gas or the gas tank is near empty).
- Start the engine. Idle the engine in drive for two and a half minutes with the A/C and rear defroster on.
- Turn the A/C and rear defrost off, and accelerate to 55 mph at half throttle.
- Hold at a steady speed of 55 mph for three minutes.
- Decelerate (coast down) to 20 mph without braking.
- Accelerate back to 55 to 60 mph at ¾ throttle.
- Hold at a steady speed of 55 to 60 mph for five minutes.
- Decelerate (coast down) to a stop without braking.
If all other emissions systems are functioning properly, completing the drive cycle above should set the emission monitors required to pass the smog check. It will not hurt to perform the drive cycle 2 or 3 times before the smog inspection. Take caution when performing drive cycles on public roadways.