Smogtips
CHOOSE YOUR CITY OR ZIPCODE:
Within:
SELECT SMOG CHECK TYPE:  

Join the community and post your question. Use our Ask-A-Tech for free now! ASE experts standing by.

Forum > Failed Smog Test > Question

Infiniti G20 High HC and CO During Smog Test

Hello. I own a 2000 Infiniti G20 and it failed for high HC and CO. During a test run at idle (around 800 rpms) everything is low. CO, HC and NOx are well below limits. When the RPM is raised to 2500 there is still no big change. But when the idle goes back to 800 rpm the HC and CO go very high and it takes some time to go back down. The HC goes over 100 and CO goes over 3.5%. It takes about 30 seconds to go back down to low readings. I changed the O2 sensor and air filter. The spark plugs are good. The PCV valve is functioning properly. The knock sensor was replaced because of a pending code. The distributor cap is in good condition. I have not checked the catalytic converter yet. Any suggestions? Defective idle air control (IAC) valve maybe?


Answer:

The fact that your Infinity G20 is taking longer than a few seconds to return to normal idle indicates either the ECU (engine control unit/computer) is not commanding the fuel injectors to cut fuel upon release of the throttle, the injectors are sticking open, the throttle position sensor is not sensing the gas pedal has been released, or the idle air control (IAC) valve is malfunctioning.

We'd recommend first starting with diagnosing the idle air control valve. The idle air control valve is prone to collecting dirt and oil, reducing its ability to open and close quickly.

Your Infiniti G20's idle RPM will change over time due to dirt collecting in the IAC. The ECU will try to compensate as much as possible. The ECU controls a solenoid inside the IAC which allows air to enter the intake manifold in order to control idle speed.

When your Infiniti's alternator load is high the ECU might command the IAC duty-cycle to 20%, when the engine load is high and speed is low you the IAC duty cycle might be as high as 50%. When at a high RPM and getting off the throttle the IAC duty cycle will reduce from 70% to 50% to 30% and so on until idle RPM is reached. With a sticking IAC getting to idle RPM will take longer.


posted by SmogTips Support

 

View SmogTips.com in: Desktop / Mobile