Smogtips
CHOOSE YOUR CITY OR ZIPCODE:
Within:
SELECT SMOG CHECK TYPE:  

Join the community and post your question. Use our Ask-A-Tech for free now! ASE experts standing by.

Forum > Failed Smog Test > Question

How can I Pass Air Injection Readiness?

My car passed everything other except the air injection emission monitor. The smog technician told me to drive my car about 100 miles and then come back. This doesn't seem to solve anything. What can I do to get the air injection to say "complete" or "pass"?


Answer:

We can only recommend driving your vehicle for 200-300 miles over the course of at least a week. Your engine's ECU must perform internal self tests to ensure all emission systems are functioning properly. These self tests then set or "complete" readiness flags, such as the Secondary Air Injection monitor.

Below you will find the generic OBDII drive cycle which if performed correctly will set all required readiness flags (also known as Emission Monitors), including the Secondary Air injection.

This OBDII drive cycle begins with a cold start (coolant temperature below 122 degrees F). We recommend achieving this by letting your vehicle cool down overnight, and beginning the drive cycle process the next day. Take extra caution while performing drive cycles on public roadways. Drive cycles can be difficult to follow under normal driving conditions.

Begin by: (Make sure you have between 1/4 and 3/4 fuel in the gas tank. The EVAP test will not run while your car has a full tank of gas or the gas tank is near empty) . 

- Start the engine. Idle the engine in drive for two and a half minutes with the A/C and rear defroster on. 

- Turn the A/C and rear defrost off, and accelerate to 55 mph at half throttle. 

- Hold at a steady speed of 55 mph for three minutes. 

- Decelerate (coast down) to 20 mph without braking or depressing the clutch. 

- Accelerate back to 55 to 60 mph at ¾ throttle. 

- Hold at a steady speed of 55 to 60 mph for five minutes. 

- Decelerate (coast down) to a stop without braking.

If all other emissions systems are functioning properly, completing the drive cycle above should set the "readiness flags" required to pass the smog check. It will not hurt to perform the drive cycle 2 or 3 times before the smog inspection.


posted by SmogTips Support

 

View SmogTips.com in: Desktop / Mobile