Smogtips
CHOOSE YOUR CITY OR ZIPCODE:
Within:
SELECT SMOG CHECK TYPE:  

Join the community and post your question. Use our Ask-A-Tech for free now! ASE experts standing by.

Forum > Failed Smog Test > Question

Ford Drive Cycle to Complete Catalyst Monitor

My Ford Mustang 3.8 Liter failed the OBD II test due to CAT monitor not ready. I have driven the Mustang per the Ford Drive Cycle specs to get it trip as ready, but it won't. The check engine light is off and there are no pending trouble codes. My Ford Mustang passed the sniff test with flying colors too.

I just can't get the CAT monitor to pass.  I checked the oxygen sensors with a scan tool live data stream and they seem to be working fine. Any help would be appreciated. Thank you.


Answer:

The average scan tool live data stream is typically not quick enough to display detailed data when voltage oscillation is high; such as with a working oxygen sensor. We'd recommend using a digital multi-meter and testing your Ford Mustang's oxygen sensors directly.

A properly functioning oxygen sensor's (front sensor) voltage should be switching between 0.1 to 1.0 volt at a rate of approximately 50 cycles per minute. An O2 sensor voltage above 0.45 volts is interpreted by the ECM as a rich exhaust, and an O2 sensor voltage signal below 0.45 volts as a lean exhaust. Check for quick voltage switching also. Over time an oxygen sensor make become "lazy". Your Ford might not be running the CAT monitor because the O2 voltages do not meet the trip criteria.

Remember also, the rear oxygen sensor should be producing a steady stream of .45 volts (approx.), indicating the catalytic converter is doing it's job.

The Ford drive cycle required to run the Catalyst Efficiency Monitor involves driving your Ford Mustang in stop & go traffic conditions. Include five different constant cruise speeds, ranging from 25 to 45 MPH over a 10 minute period.


posted by SmogTips Support

 

View SmogTips.com in: Desktop / Mobile