Smogtips
CHOOSE YOUR CITY OR ZIPCODE:
Within:
SELECT SMOG CHECK TYPE:  

Join the community and post your question. Use our Ask-A-Tech for free now! ASE experts standing by.

Forum > Failed Smog Test > Question

1995 Dodge Ram 2500 Failed High HC Only at Idle

Hello. I own a 1995 Dodge Ram 2500 v10 gas engine truck. It failed the smog test because the hydrocarbon was too high, but only at idle. It passed all the emissions tests while running but not passing HC while in idle. All other readings are so far below the standard. I have just replaced the spark plugs and will be changing the oil soon also.


Answer:

Vacuum Leaks - We recommend first inspecting your Dodge Ram truck's vacuum lines. Ensure your have no vacuum leaks. During idle, intake manifold vacuum is at its highest. Any vacuum leak will cause a lean mixture and increase HC emissions. Once the engine is off idle, HC will return to normal because the fuel injection system will present more fuel to the combustion chambers, neutralizing the vacuum leak. So, checking for vacuum leaks is the first step.

Ignition Control Module - Once a quick visual inspection has been conducted for disconnected, brittle, or broken vacuum hoses, move on to inspecting the ignition system wiring, most importantly ignition control module on the distributor. With off-idle condition timing needs to advance. A damaged ignition control module may trigger the ECM to run the engine with advanced (or retarded) timing at idle, instead of correctly controlling ignition timing. If you have access to a timing gun, you may use to check ignition timing advance while the engine is at idle and 2500 RPM. Using the timing gun, if no change in timing is detected while at idle and 2500 RPM, diagnose the ignition control module further. Note, ignition timing on your vehicle can not be set or changed. It is controlled by the ECM.

MAP (Manifold Absolute Pressure) Sensor - The MAP sensor should be checked for proper operation as well. The MAP (manifold absolute pressure) sensor is responsible for letting your Dodge Ram truck's ECM (engine control module) know how much intake vacuum exists. This simple and inexpensive sensor is crucial for proper air/fuel mixture ratio at both idle and off-idle conditions.

How to Test the MAP Sensor - You may test the MAP sensor using a voltmeter set to measure voltage. You should see an increase in voltage as RPMs increase (intake vacuum decreases). At idle you should see between to 1 to 1.5 volts. Off idle, voltage should start increasing to a maximum of 5.0 volts. The measurement should be taken from the middle wire (should be dark green/red) of the three wire connector at the MAP sensor. You must leave the MAP sensor connected during this test, and back probe the connector. If you have a hand vacuum pump, you may use it to apply vacuum to the sensor, as opposed to running the engine. Disconnect the vacuum line leading from the intake manifold to the sensor and attach your hand vacuum pumps vacuum line instead. Turn your Dodge truck's ignition on, do not start the engine, and conduct the MAP sensor test. If no voltage exists, either at no vacuum or 20in HG vacuum, inspect the other two wires for power (12 volts) and ground. Violet/White wire should have 5 volts while the ignition is on. Blue wire is connected the ground.


posted by SmogTips Support

 

View SmogTips.com in: Desktop / Mobile